شما عضو این انجمن نبوده یا وارد نشده اید. لطفا برای مشاهده کامل انجمن و استفاده از آن وارد شوید یا ثبت نام کنید .

امتیاز موضوع:
  • 24 رأی - میانگین امتیازات: 2.92
  • 1
  • 2
  • 3
  • 4
  • 5

[-]
کلمات کلیدی
to s a ring size? measure man for how finger

How to Measure a Man's Finger for Ring Size?
#1
[b]Get Sized at a Jeweler:[/b] To ensure the most accurate ring size, we recommend you visit your local jeweler for a professional sizing.
[b]Measure using an existing ring:[/b] Borrow one of your partner’s rings and slide it down a tapered candle. Measure the circumference of the candle where the ring stops. Use those measurements and the chart below to determine the correct ring size. 
[b]Printable Ring Sizer: [/b]Follow the directions below and use our printable ring sizer.
[b]Additional Information on sizing:[/b]
[b]Do comfort ring sizes run differently? [/b]Comfort fit rings tend to fit looser than standard fit rings of the same size. As a general rule of thumb, when purchasing a comfort fit ring, you should choose a size that is about a half size smaller than your standard fit ring size. All sizing you perform from this page is considered standard ring sizes not comfort fit.
[b]What is the Average Men’s Ring Size? [/b]Normally ranging from 8 to 14. Sizes 8 – 12 are among the most often purchased. The average for men is 10.
[b]To measure using a paper strip.[/b]
In order to print the ring sizer above, be sure that your printer is set to 100%. Make sure that you have not reduced the print size in your printer ‘page setup’ area. You can verify that the sizer printed correctly by measuring it with a ruler; it should measure from A to B: 3 1/2 inches long.
Once you have printed the sizer, follow these directions to find your ring size:

  1. Cut out the ring sizer

  2. Cut a slit for Slot “A”

  3. With the numbers facing out, wrap the sizer around the finger on where the ring will be worn.

  4. Pull the pointed end Tab “B” through Slot “A” until the sizer is very snug.

  5. Measure your knuckle the same way following the previous steps.

  6. The larger of the two numbers aligned with Slot “B” is your ring size.
If the measure lands between two numbers your size is a half size Ex: Between 5 and 6 ring size: 5.5. If half sizes are not available, order the next largest size.  


https://ringsize.net/
پاسخ


پرش به انجمن:


کاربرانِ درحال بازدید از این موضوع: 1 مهمان