+- باشگاه کاربران روماک (https://forum.romaak.ir)
+-- انجمن: متفرقه (https://forum.romaak.ir/forumdisplay.php?fid=16)
+--- انجمن: بازارچه (https://forum.romaak.ir/forumdisplay.php?fid=18)
+--- موضوع: How to Measure a Man's Finger for Ring Size? (/showthread.php?tid=8964)
How to Measure a Man's Finger for Ring Size? - seofar70 - ۰۰/۶/۲۱
[b]Get Sized at a Jeweler:[/b] To ensure the most accurate ring size, we recommend you visit your local jeweler for a professional sizing.
[b]Measure using an existing ring:[/b] Borrow one of your partner’s rings and slide it down a tapered candle. Measure the circumference of the candle where the ring stops. Use those measurements and the chart below to determine the correct ring size.
[b]Printable Ring Sizer: [/b]Follow the directions below and use our printable ring sizer.
[b]Additional Information on sizing:[/b]
[b]Do comfort ring sizes run differently? [/b]Comfort fit rings tend to fit looser than standard fit rings of the same size. As a general rule of thumb, when purchasing a comfort fit ring, you should choose a size that is about a half size smaller than your standard fit ring size. All sizing you perform from this page is considered standard ring sizes not comfort fit.
[b]What is the Average Men’s Ring Size? [/b]Normally ranging from 8 to 14. Sizes 8 – 12 are among the most often purchased. The average for men is 10.
[b]To measure using a paper strip.[/b]
In order to print the ring sizer above, be sure that your printer is set to 100%. Make sure that you have not reduced the print size in your printer ‘page setup’ area. You can verify that the sizer printed correctly by measuring it with a ruler; it should measure from A to B: 3 1/2 inches long.
Once you have printed the sizer, follow these directions to find your ring size:
- Cut out the ring sizer
- Cut a slit for Slot “A”
- With the numbers facing out, wrap the sizer around the finger on where the ring will be worn.
- Pull the pointed end Tab “B” through Slot “A” until the sizer is very snug.
- Measure your knuckle the same way following the previous steps.
- The larger of the two numbers aligned with Slot “B” is your ring size.
https://ringsize.net/